Feb 11, 2009 · Well after 3 months of fooling around I finally got it done. It is a motorized tool box. I have been working at my present job almost 3 years and ever since I got here I have wanted to build a self propelled tool box. our plant is quite large and there is a difference of 10 feet between 2 building connected by a long ramp and loading dock are halfwy between.

Jan 6, 2025 · The bit is painless, so you do not even know you are bit. A black widow is painful at the time of the bite. I had a 4-year-old patient, and on presentation, the parents had the dead smashed spider, and the child looked sick. she picked up a tool off the deck and yelled ouch dropping the tool and the grandpa smashed the spider as it tried to run ...

Mar 22, 2023 · My change was that I flipped the fan around inside the sheet metal housing. Then I turned the connection box 90 degrees and mounted it as close to the fan end as possible. I took off the flanges on the side opposite the fan and then inserted the sheet metal box into the wall from the inside until the connection box hit the wall. Like this:

Feb 10, 2022 · I ended up with a chainsaw multi-tool that I keep on my chainsaw toolbelt (Mine was an older version of this tool, but very similar). It has a bar nut socket, 4mm allen wrench (fits Husky and Echo saws), a T-27 torx (for Stihl saws), large and small screwdriver, sparkplug wrench, bar slot cleaning tool. It's come in handy on a number of occasions.

Sep 2, 2014 · Take out the guides ,both roller and ceramic. check and adjust the mast guides. check that the blade runs neutrally on the band wheels when at correct tension,correct cant control if required.check blade for across the bed to get the blade neutrally [without guides] +1/16 above parallel to the outer side.check blade is level with the bed length ...

Aug 1, 2016 · Venting - Bad new box of blades? Started by alan gage on Sawmills and Milling. 33 Replies 3065 Views Last post: November 09, 2020, 12:57:33 PM by ladylake : Venting on a Logger Started by just_sawing on Sawmills and Milling. 6 Replies 1721 Views Last post: July 08, 2012, 03:01:03 PM by beenthere

Apr 8, 2010 · Stihl MS361, 460 & 200T, Jonsered 490, Jonsereds 90, Husky 350 & 142, Homelite XL and Super XL

Sep 1, 2008 · I`ve got the Stihl tool and it`s nice with it`s fancy plastic handle and all, but as Cut4Fun says, a business card will do the trick, and yes, it is actually sort of critical. .012" - .015" clearance between the magnets and the coil pickups.

Jun 24, 2009 · I have found when welding especially pieces at a right angles don't butt them togather leave say 1/16 "tack one side then you can use a square and be able to move it square then tack the outher side.This also gives you better weld penetration.Tacking everything then double checking and alternate your welds so you don't get any one area too hot.

Apr 20, 2017 · Ok then it's probably a 3305 or 3315 which is self contained. If that's the case then it doesn't matter that your machine is open center. you can just run the winch off your pto the only thing is you can't winch or drop your hitch when the clutch is pushed but once you get used to that it's not that big of a deal.